Table of Contents
Advertisement
programme satellite receiver
receiver (see receiver manual) and put a tape in the VCR.
get to the output/input set screen
SET
using the A and B buttons and press O (or E).
select l-2 select mode
buttons. Press O (or E) to select
Press / on the Remote Control to set the tape speed to
set tape speed
engage vcr in auto mode
indicator on the VCR lights up and the VCR turns off automatically. Any signal detected at the
connector will automatically start the VCR recording; when the signal
AV2 (L-2) IN/DECODER
stops, so will the VCR.
Notes
Auto Satellite Prog Recording is only possible using the
connectors
connector.
You cannot put the VCR into
timer mode
Recording Mode.
r The number of programmes recorded will not be displayed on the VCR display
panel when the r button is pressed.
Auto Satellite Prog Recording is not possible if your satellite receiver does
timer recording
not have a timer.
The
c indicator light flashes when Auto Satellite Prog Recording is in progress.
SAT
indicator
To disengage the VCR during Auto Satellite Prog Recording, press the o button.
disengage
The VCR will stop recording and turns off.
When recording two or more programmes consecutively, you cannot set a different
tape speed
tape speed for each programme. The first speed selected will apply to all programmes in that
recording session.
The
system will not work during Auto Satellite Prog Recording.
B.E.S.T.
b.e.s.t.
just clock Just Clock
The VCR will only react to the start of an incoming signal at the
incoming signal
connector. If you try to engage Auto Satellite Prog Recording Mode whilst the
IN/DECODER
satellite receiver is powered on, the
You must power the satellite receiver off then on again to begin recording in these circumstances.
You can record in the same way from a cable system as long as you connect the
cable input
cable system has a timer on/off function and is connected to the
Some satellite receivers output signals even when turned off. These receiv-
incompatibilities
ers cannot be used with this VCR in this way.
Enter the details of the programme into your satellite
Press m. Move the highlight bar to
Move the highlight bar to
or
SAT
A/V
Press and hold
SAT
TIMER MODE
does not work when in Auto Satellite Prog Recording mode.
c indicator light will flash but the VCR will not record.
SAT
advanced features
L-2 SELECT
using the A and B
. Then press m.
c on the VCR for about 2 seconds. The
AV2 (L-2) IN/DECODER
when using Auto Satellite Prog
AV2 (L-2) IN/DECODER
49
OUTPUT/INPUT
,
or
.
SP
LP
EP
c
SAT
AV2 (L-2)
.
Advertisement
Chapters
Table of Contents
