Table of Contents
Advertisement
12
EN
Preset Download
Auto Channel Set by Downloading
from TV/Auto Clock Set/Auto Guide
Program Number Set
If you have connected the unit to your TV via the AV connection
(
pg. 9), the unit will automatically perform Preset Download
instead of the Auto Set Up in step D on page 11. After
downloading, the unit sets the clock and Guide Program
numbers automatically.
ATTENTION
You can use this function only with a TV offering T-V Link,
etc.* Be sure to use a fully-wired 21-pin SCART cable.
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link or DATA LOGIC via fully-wired 21-pin SCART
cable. The degree of compatibility and available functions may
differ by system.
● Slide the TV/VCR/DVD switch to the right.
● Perform steps A to C of "Auto Set Up" on page 10 before
continuing.
NOTES:
● For details, refer to the instruction manual of your TV.
● In areas where no TV station transmits a PDC (Programme
Delivery Control) signal, the unit can perform neither Auto
Clock Set nor Auto Guide Program Number Set.
● If there is a power cut, or if you press 1 or SET UP MENU
while downloading or set up is in progress, it will be
interrupted; be sure to turn off the unit power once and try
again from the beginning.
● Auto Clock Set may not function properly depending on the
reception condition.
● On this unit, the characters available for station names (ID) are
A–Z, 0–9, –,
, + and
f
I
stations may differ from those of your TV. (
(space). Some names of downloaded
pg. 73)
INITIAL SETTINGS (cont.)
A
Perform Preset Download.
Press OK. The AUTO SET/T-V LINK display appears on
the front display panel and/or on the TV screen.
On the front display panel
Press rt to select "CH – –" and press OK or e.
On the on-screen display
Press rt to move the
highlight bar (pointer) to
"T-V LINK" and press OK or
e.
Preset positions on the front display panel increase from
"CH 1"; do NOT press any button on the unit or remote
control until the front display panel shows clock time,
"(CH) 1" or "– –:– –" as illustrated on page 13.
● If you are using the on-screen
display, the T-V LINK screen
will appear. Then the GUIDE
PROG SET screen will appear
during Guide Program
Number Set. When Preset
Download is completed,
"COMPLETED" appears for
about 5 seconds, then the
normal screen appears.
● If you press any button on the
unit or remote control while
downloading is in progress, it
will be interrupted.
B
Set the video channel.
Set the video channel to off manually. (
After "Preset Download" is completed, perform
"Monitor Set (DVD deck)" on page 14.
pg. 75)
Advertisement
Table of Contents
