Three-Step Quick Start; Auto Setup - JVC HR-S6855EK Instructions Manual

10

three-step quick start

Three-Step Quick Start
For Step
Auto Setup or Preset Download.
before you start
Check that the VCR is
turned off and no
cassette is inserted
Load the batteries into
the Remote Control
Refer to the Remote
Control diagram
on pages 6–7
Unless indicated
otherwise, use the
buttons on the Remote
Control
Check that the
connection is completed
Turn on the TV
– –:– –
O
TE PR
TV
TV/VCR AUDIO – –:– –
1 2 3
. , /
ABC DEF
2
4 5 6
GHI JKL MNO
VPS/PDC DAILY/QTDN. WEEKLY/HEBDO
7 8 9
PQRS TUV WXYZ
0000 AUX 4
0
START STOP
DATE PR
DEBUT FIN
EXPRESS
?
1 PROG 30 SEC
, be sure to perform either of the methods:

Auto Setup

START AUTO SETUP
Press the o button. If 'Auto' appears on the display panel, press O (or E).
what will happen?
word 'Auto'. Do not press any button on the VCR or the Remote Control.
note If you have connected both the RF cable and the fully-wired 21-pin SCART
cable, and if your TV offers T-V Link, etc., and the TV is turned on, the VCR
automatically performs the Preset Download (
for Auto Setup function.
Auto Setup is running: don't
touch any buttons
AUTO SET
PLEASE WAIT
[MENU]: EXIT
SELECT THE VIDEO CHANNEL
When
Auto Setup
If you have only used the RF
rf cable only
Cable to connect the VCR to the TV, you will see
this display. The number is the channel on the TV that the
to be the video channel. In the example, we have presumed that channel 36 is
vacant and have set the VCR to 36:
Now tune the TV set to channel 36 (refer to TV manual if necessary);
you should see two vertical white bars appear on the TV screen. If
the bars do not appear or are not clear, choose another vacant
channel and try again. If you cannot obtain the vertical white bars
on any channel between 22 and 69, consult your local JVC dealer.
rf and scart connection
to connect the VCR to the TV with both the RF
Cable and a 21-pin SCART Cable (not provided), you need to press the
on the Remote Control until the figure reads '– –'. This is because you will use the
TV in AV mode to view video pictures and therefore do not need a dedicated video
channel.
The display panel on the front of the VCR will show the
The VCR is automatically setting up the tuner
channels, clock, the VIDEO Plus+ assigned Guide
Program numbers and the video channel. This only
happens the first time that the VCR is turned on.
rf and scart connection
connect the VCR to the TV with both the RF Cable
and a 21-pin SCART Cable (not provided) and the
TV set is in its AV mode (see the TV manual), you
will see the following information displayed on
your TV screen:
Your TV screen during Auto Setup if SCART is used
has finished, you will see the following display panel on your VCR:
If you have chosen
pg. 11) even if you select 'Auto'
If you have chosen to
has chosen
Auto Setup
PR
button