Three-Step Quick Start; Auto Setup - JVC HR-S6955EK Instructions Manual

10

three-step quick start

Three-Step Quick Start
before you start
Check that the VCR is
turned off and no
cassette is inserted
Load the batteries into
the Remote Control
Refer to the Remote
Control diagram
on pages 6–7
Unless indicated
otherwise, use the
buttons on the Remote
Control
Check that the
connection is completed
Turn on the TV
– –:– –
O
TE PR
TV
– –:– –
TV/VCR AUDIO
1 2 3
2
4
5 6
VPS/PDC DAILY/QTDN. WEEKLY/HEBDO
7 8 9
0000 AUX 4
0
START STOP
DATE PR
DEBUT FIN
EXPRESS
? 30 SEC
1 PROG

Auto Setup

START AUTO SETUP
Press the o button.
what will happen? The display panel on the front of the VCR will show the
word 'Auto'. Do not press any button on the VCR or the Remote Control.
VCR
Auto Setup is running: don't
touch any buttons
AUTO SET
PLEASE WAIT
[MENU]: EXIT
SELECT THE VIDEO CHANNEL
When has finished, you will see the following display panel on your VCR:
Auto Setup
rf cable only If you have only used the RF
Cable to connect the VCR to the TV, you will
see this display. The number is the channel on
the TV that the
Auto Setup
video channel. In the example, we have presumed that channel 36 is vacant and
have set the VCR to 36:
rf and scart connection If you have chosen
to connect the VCR to the TV with both the RF
Cable and a 21-pin SCART Cable (not provided),
you need to press the
PR
Control until the figure reads '– –'. This is because you will use the TV in AV mode
to view video pictures and therefore do not need a dedicated video channel.
FINISH AUTO SETUP
Press and move on to
oops! If there is a power cut or you accidentally press a button during
, turn the VCR off and then on again. Re-perform
Setup
The VCR is automatically setting up the tuner
S-VHS
channels, clock, the VIDEO Plus+ system assigned
Guide Program numbers and the video channel.
REVIEW
This only happens the first time that the VCR is
turned on.
rf and scart connection If you have chosen to
connect the VCR to the TV with both the RF Cable
and a 21-pin SCART Cable (not provided) and the
TV set is in its AV mode (see the TV manual), you
will see the following information displayed on
your TV screen:
Your TV screen during Auto Setup if SCART is used
has chosen to be the
Now tune the TV set to channel 36 (refer to TV manual if
necessary); you should see two vertical white bars appear
on the TV screen. If the bars do not appear or are not
clear, choose another vacant channel pressing PR button
on the Remote Control and try again. If you cannot
obtain the vertical white bars on any channel between 22
and 69, consult your local JVC dealer.
button on the Remote
to check the results.
Step 2
S-VHS
VCR
REVIEW
S-VHS
VCR
REVIEW
Auto
.
Auto Setup