Operation Setup (Recovery Rec, Rec Indicator, Repeat Rec) - JVC VR-509E Instructions Manual

Recording Camera Images
Setting the REC PATTERN SET (continued)
Procedure for Changing the Number of Cameras
1. Take a note of all the [REC PATTERN SET] data
settings (F.RATE, QLY and M.DET on NORMAL REC/
ALARM REC) when [STANDARD] or [REC PATTERN 1
to 9] is in use.
2. Amend the setting for the number of operation
cameras with [CAMERA SETUP] as explained on
page 20.
3. When the [CAMERA SETUP] parameters have been
amended with procedure 2, reset the [REC PATTERN
SET] data settings.
* It is recommended that the original data is backed up onto
a USB memory or other storage device before the
settings are temporarily changed.
32
Operation Setup (RECOVERY REC, REC
INDICATOR, REPEAT REC)
1. Press the [MENU] button.
• The [MENU] → [OPERATION MENU] → [ONSCREEN/
OPERATION] → [OPERATION] screens will be
displayed in this sequence in accordance with the
[MENU Screen Operations] explained on page 17.
OPERATION
RECOVERY REC PRIOR STATE
REC INDICATOR
REPEAT REC
OPELOCK RELEASE
OPERATION LOCK REC STOP
REC STOP
PLAY
CHANGE SETTING
CHANGE MONITOR
OPERATION
DVD
2. Select your desired item with the [ / ] keys, and then
change the value of the setting with [–/+].
Settings
RECOVERY REC
Sets whether or not to perform recovery recording after a power
failure.
OFF: Remains at OFF.
COMPULSION REC:Normal recording is started.
PRIOR STATE: Recording is started in accordance with
the same settings prior to the power failure
only when recording was being carried out
before the power failure occurred.
* Recording will be carried out in accordance with the timer
settings during timer operations.
REC INDICATOR
Sets whether or not to illuminate the recording indicator during
recording.
OFF: Not illuminated.
ON: Illuminated.
REPEAT REC
Sets the operations to be carried out when the hard disk runs
out of space.
OFF: Recording is stopped.
ALARM LOCK:
Recording is continued while overwriting old recordings.
However, the alarm recording (including emergency and
passcode error recording) will not be overwritten.
ALL: Recording is continued while overwriting all old recordings.
* Details on REPEAT REC are explained on page 104.
3. Press the [SET] button.
• The confirmation screen will be displayed.
4. Select "SAVE" with [ / ], and then press the [SET].
ON 2.
ALL
BASIC
OFF
OFF
OFF
OFF
OFF
OFF