Installation Requirements; Gas Supply Requirements; Tools And Parts; Dimensions - Maytag CWG3600AAS13 Installation Instructions Manual

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
• Tape measure • Marker or pencil
• Phillips screwdriver • Pipe-joint compound
resistant to LP gas
• Flat-blade screwdriver
• 1/8"Flat-blade screwdriver • 3/16"(4.8 mm) carbide-tipped
masonry drill bit (for
• Level concrete/ceramic floors)
• Hand or electric drill • Noncorrosive leak-detection
solution
• Wrench or pliers
For LP/Natural Gas
• Pipe wrench Conversions
• 1%6" combination wrench • 1/2"combination wrench
• 1/8"(3.2 ram) drill bit • 7 mm nut driver
(for wood floors)
• Masking tape
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See "Electrical Requirements" and
"Gas Supply Requirements" sections.
IMPORTANT: Observe all governing codes and ordinances. Do
not obstruct flow of combustion and ventilation air.
It is the installer's responsibility to comply with installation
clearances specified on the model/serial rating plate. The
model/serial rating plate is located at bottom front face
surface on the right-hand side of the oven frame.
• The oven should be located for convenient use in the kitchen.
Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
All openings in the wall or floor where oven is to be installed
must be sealed.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
Grounded electrical supply is required. See "Electrical
Requirements" section.
Proper gas supply connection must be available. See "Gas
Supply Requirements" section.
IMPORTANT: To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used
will not discolor, delaminate or sustain other damage. This oven
has been designed in accordance with the requirements of UL
and CSA International and complies with the maximum allowable
wood cabinet temperatures of 194°F (90°C).
Product Dimensions - Single Oven
B
A. 221/4'' (56.8 cm) max. recessed width
B. 391/4'' (99. 7 cm) max. overall height
C. 23%" (60.6 cm) overall width
D. 22%" (57.5 cm) max. recessed depth
E. 3 73/4"(95.9 cm) recessed height
Cabinet Dimensions - Single Oven
Single Oven Installed in Cabinet
F
E
A
I II I
B
t
C
A. 24" (61 cm) min. cabinet width
B. 11/_"(3.8 cm) top of cutout to bottom of upper cabinet
door
C. 14" (35.6 cm) min. bottom of cutout to floor
D. 22%" (56.8 cm) cutout width
E. 11/_ '' (3.8 cm) min. bottom of cutout to top of cabinet door
F. 38" (96.5 cm) cutout height
NOTE: For gas supply pipe, provide a 3" x 3" opening in the back
wall of the cabinet centered 7" from the left rear corner and 3"
above the bottom of the cabinet cut out. Install a 120 volt
electrical outlet in the back wall of the cabinet centered 6" from
the right rear corner and 4" below the top of the cabinet cutout.