Table of Contents
Advertisement
ADDITIONAL
INSTRUCTIONS
FOR EXPORT MODELS
(Not U.S. or Canada)
Contact the distributor
that sold the appliance
or: Maytag
international,
1475 East Woodfie(d
Road Schaumburg,
IUJnoJs60173 Phone: 847-273=3100,
for information
on product, shipping
damage,
replacement
parts and accessories.
Maytag dryer models manufactured
for operation
on 60 Hz AC are not designed for use on
50 Hz AC electrical
service and conversion
of the product from 60 to 50 Hz operation
is not
recommended.
For additional
information
on 50 Hz products,
contact
Maytag International.
The electric service requirements
can be found on the data label located on the front of the
dryer behind the door.
EXPORT ELECTRIC
MODELS
Export electric models are manufactured
for operation
on either 230/240
volt, 50 Hz or 220
volt, 60 Hz approved
electric service. A two-wire
approved
electrical
service with a 30-
ampere fuse or circuit breaker is required.
The dryer must be properly
grounded
with a
ground wire.
IMPORTANT:
When permitted
by local codes, the dryer electrical
supply may be connected
by means of a new power supply cord kit, marked for use with clothes dryers, that is agency
listed, rated at 240 volts minimum,
30 amperes
with two No. 10 copper wire conductors
terminated
with closed loop terminals,
open-end
spade lugs with turned up ends or with
tinned leads. Do not reuse a power supply cord from an old dryer. The power cord or electric
supply wiring must be retained at the dryer cabinet with a suitable
agency listed strain relief.
2-W(RE SYSTEM CONNECT(ONS
1. Loosen or remove center termina( block screw.
2. Connect
neutral wire (white or center wire) of power supply cord to the center, silver
co(ored termina(
screw of the terminal
block. Tighten
screw.
3. Connect
the other wires to outer terminal
block screws. Tighten
screws.
4. Tighten
strain
relief screws.
5. insert
tab of termina(
block cover
into slot of dryer rear panel.
Secure
cover with
hold=down
screw.
1. External
ground connector
2. Neutral
grounding
wire (green/yellow)
3. Center silver=colored
term)hal
block screw
4. Neutral
wire (white or center wire)
5. 3/4 in. (1.9 cm) ULdisted
strain relief
J BEFORE
OPERAT(NG
OR TEST(NG,
be sure the machine
is propedy
grounded.
12
Hide quick links:
Advertisement
Table of Contents
