Electrical Requirements - Maytag MLE24PDAGW0 Installation Instructions Manual

Electric Shock Hazard
This dryer must be earthed.
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electric shock.
w
This is a 3-wire dryer which must be earthed.
This dryer is supplied without an electric cord and plug; it must
be connected by a competent electrician. See "Electrical
Requirements."
1. Using a 102 mm (4") clamp, connect vent to exhaust outlets
in dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 102 mm (4") clamp.
2. Move dryer into final position. Do not crush or kink vent.
Make sure dryer is level.
1.
2.
3.
With dryer in final position, place level on top of the dryer, first
side to side; then front to back. If the dryer is not level, adjust
the legs of the dryer up or down until the dryer is level.
Reconnect power to dryer.
Check dryer operation.
Select the full heat cycle (not the air cycle), start and allow
the dryer to complete a full cycle to make sure it is working
properly. Dryer will stop when the time is used up.
NOTE: Dryer door must be closed for dryer to operate. When
door is open, the dryer stops. To restart dryer, close door and
resetect your cycle.
ELECTRONIC CONTROL SETUP
See the programming guide for information on setup.
MAINTENANCE INSTRUCTIONS
Maintenance instructions:
[] Clean lint screen after each cycle.
[] Removing accumulated lint:
• From inside the dryer cabinet:
Lint should be removed every 2 years or more often,
depending on dryer usage. Cleaning should be done by a
qualified person.
• From the exhaust vent:
Lint should be removed every 2 years, or more often,
depending on dryer usage.
If dryer does not operate check the following:
[] Electric supply is connected.
[] Circuit breaker is not tripped or house fuse is not blown.
[] Door is closed.
[] Controls are set in a running or "ON" position.
[] Cycle has been selected.
If you need assistance:
Contact your authorized Maytag Commercial Laundry distributor,
or visit: www.MaytagCommercialLaundry.com. When you call,
you wilt need the dryer model number and serial number. Both
numbers can be found on the serial-rating plate located on your
appliance.