KitchenAid YKHMS155LBL2 Installation Instructions Manual page 7

Lx}c@e S ud(s}
NOTE: If no wall studs exist within the cabinet opening, do not 1. Using a stud finder, locate the edges of the wall stud(s) within
install the microwave oven, the opening.
See illustrations in "Possible Wall Stud Configurations," 2. Mark the center of each stud, and draw a plumb line down
each stud center. See illustrations in "Possible Wall Stud
Configurations."
Possible Wall Stud Configurations
These depictions show examples of preferred installation configurations with the mounting plate.
No Wall Studs at Corner Holes
Figure 1
No Wall Studs at Corner Holes
Figure 2
_i_ _i_
,ii'
i i I
i i
i i
NOTE: If wall stud is behind vent opening, only ventless
(recirculating) or roof venting installation can be done.
.D
One Wall Stud at Two Corner Holes
Figure 3
Wall Studs at All Four Corner Holes
Figure 4
A. Corner holes (on mounting plate)
B. Cabinet opening vertical centerllne
C. Wall vent opening (on mounting plate)
D. Wall stud centerllnes
E. Holes for lag screws
F. Support tabs
G. Mounting plate center markers