Installation Instructions; Install Cooktop - KitchenAid KGCD807XWW00 Installation Instructions Manual

INSTALLATION INSTRUCTIONS
Decide on the final location for the cooktop.
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
1=
2.
3.
4.
S
Open carton as instructed on product packaging.
Remove shipping materials and tape from cooktop.
Remove the removable grease filter by lifting the filter out.
For island or peninsula installations, go to the "Rotate Blower
- Optional" section.
D
C
,j/
/
A
A. Removable grease filter
B. Left side grate
C. Vent grille
D. Right side grate
5. Using 2 or more people, remove the cooktop from the carton.
REMEMBER: An undercounter built-in oven cannot be
installed under this cooktop.
6. Place cooktop right side up into the cutout.
NOTE: Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning is
needed, lift entire cooktop up from the cutout to avoid
scratching the countertop.
7. Connect blower exhaust scroll to ducting.
8. Use vent clamps to secure the ducting to the blower exhaust
scroll.
9. Reinstall grease filter.
10. Reinstall vent grille.
IMPORTANT: The following additional steps must be performed
if the product is being installed in peninsula or island cabinetry.
The blower exhaust scroll is shipped from the factory set to
exhaust straight out the back of the cabinet through an exterior
wall.
D_ Z ........
c .....\
A. Blower exhaust scroll
B. Plenum
C. Blower motor
D. #10-32 Iocknuts (4)
E. Motor mounting plate
To rotate blower:
1. Remove the right and left grates. Then remove the vent grille.
See illustration in Step 4 of the "Install Cooktop" section.
2. Locate the 4 Iocknuts inside the plenum.
i
D
3.
A. #10 - 32 Iocknut
B. Plenum
C. Flat washer
D. Blower guard
Use 3/8"socket and ratchet handle to loosen the nut half of a
rotation. Repeat this process for each of the 4 nuts.
10