Loading Tabbed Sheets In Tray 1, 2, Or 3 - Konica Minolta DP-85 Operation Manual

Maintenance & Supplies
Loading Paper (continued)

Loading Tabbed Sheets in Tray 1, 2, or 3

Load offset tabbed sheets so that the tab extensions are on the left at the rear (not front) of the
tray. The tab extension width should be 12.5 mm or less.
When loading tabbed sheets in the tray, be sure to specify the paper type as Tab paper in the
Key Operator mode; otherwise mishandled paper may occur.
The top sheet is designated face down as the first tab of the finished set. Subsequent offset
tab sheets follow in sequence.
Rear
Rear
Example: 3 Tabbed sheets loaded in position for one finished set.
Front
1st TAB
2nd TAB
3rd TAB
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Front
1st TABS
2nd TABS
3rd TABS
- 45 -
Section 3
Management
Printed
side
ONE FINISHED SET
1st TAB
Section 3
Section 3
Management
Section 3
Management
Section 1
Management
Introduction
Printed
side
1st TAB
Section 1
2nd TAB
Introduction
3rd TAB
2nd TAB
Section 1
Section 1
Introduction
Introduction
3rd TAB
3 FINISHED SETS