Removing A Paper Misfeed; J2/J3-Copier - Minolta CSPRO EP1031 Manual

36
5. J Display

Removing a Paper Misfeed

J2/J3-Copier

NOTE
Be careful not to touch the areas marked with
[ High Voltage] and [
Open the Front Door. While pressing with
1
one hand on the area marked with
turn the Lock Release Lever clockwise to
swing up the Upper Unit.
While holding up the fusing unit cover on
2
this side, remove the paper.
CAUTION: HOT
The fusing unit and its surrounding areas may be
extremely hot. DO NOT TOUCH any area
except the black cover for the fusing unit.
Remove any paper misfeed in the transfer area.
3
Gently close the upper unit and then close
4
the Front Door.
Caution: Hot].
,
C1159O081DA
C1159O102DA
C1159O103DA
C1159O104DA
Open the Right Door and remove the
5
paper misfeed in the paper take-up section.
Pull out the drawer, remove the paper and
6
push the lifting plate down.
Fan the sheets of paper, put them back in
7
the drawer and slide it in the copier.
NOTE
Make sure the paper is positioned below the
catches of the drawer.
Close the Front Door.
8
NOTE
If J2 or J3 appears, during the multi copy
cycle, check the copies on the Copy Tray and
return the originals needed to the Document Feed
Tray to complete the copy job.
C1159O070DA
C1159O065DA
C1159O066DA