When The Message "A Paper Misfeed Has Been Detected." Appears; Misfeed Clearing Procedures - Minolta EP3000 Operator's Manual

Misfeed Clearing Procedures

Copier (Fusing/Transport Section)
NOTE
Be careful not to touch the areas marked with
High Voltage and
with bare hands.
Open the Front Door. Turn the Lock Release
1
Lever counterclockwise to unlock and swing
up the Upper Half of the copier. Then lock
Stopper M2 .
Holding up Fusing Unit handle
2
out the sheet of paper in the direction of the
arrow.
CAUTION : HOT
The Fusing Unit and its surrounding areas may
be extremely hot. DO NOT touch any part except
the Fusing Unit Handle (yellow).
Remove any sheet of paper from the
3
transport section.

4. When the Message "A paper misfeed has been detected." Appears

4
Caution: HOT
C1174O028AA
, pull
M1
1139O068
C1175O023AA
Slightly lift up the Upper Half of the copier
and unlock Stopper
M2
down and lock the Upper Half of the copier.
Then, close the Front Door.
5-13
. Gently swing
C1174O029AA