Error Code - Kyocera FS-1116MFP Facsimile Operation Manual

Error Code

xxxx01
1xxx11
1xxx12
1xxx13
2xxx14
xxxx15
xxxx16
xxxx18
1xxx19
1x0130-1x0179
1xxx30-1xxx79
2x0130-2x0179
2xxx30-2xxx79
3xxx44
OPERATION GUIDE
Error Code
Refer to the table below for error codes.
Transmission was interrupted by pressing [Stop/Clear].
Transmission was interrupted due to jam in the document processor. Set
original and try sending again.
Transmission was interrupted because the left cover of the document
processor is opened. Close the cover and try sending again.
Transmission was interrupted due to shutting down of the facsimile. Try
sending again.
Reception failed because the facsimile memory is full. If memory reception
is enabled, ask the other party to send again. Make sure that paper is fully
loaded, or no jam occurred in your facsimile.
No dial tone was detected. Press [On-Hook] on the operation panel to
confirm the tone. If no tone sounds, check if the modular cable is firmly
connected.
Transmission failed in spite of auto redialing. Wait for a few moment, or
check if the destination is correct.
Waiting transmission job was deleted because the facsimile was shut
down. Try sending again.
Transmission job was deleted. Try sending again.
Transmission error occurred. If error occurs persistently, set
communication speed to 14.4 Kbps, and check if transmission succeeds or
not. (Refer to Tx Speed on page 5-7.)
Transmission error occurred. Try sending again. If error occurs
persistently, change the setting of ECM communication to Off (refer to ECM
on page 5-7), or the setting of coding restriction (Codec Disable on
page 5-7), and check if transmission succeeds or not.
Reception error occurred. If error occurs persistently, set communication
speed to 14.4Kbps, and check if reception succeeds or not. (Refer to Rx
Speed on page 5-7.)
Reception error occurred. Try sending again. If error occurs persistently,
change the setting of ECM communication to Off (refer to ECM on page 5-
7), or the setting of coding restriction (Codec Disable on page 5-7), and
check if reception succeeds or not.
Error occurred during polling reception. Ask the other side if polling
transmission is set or not.
NOTE:
x means an arbitrary numeric character.
Problem and Corrective Action
Trouble Shooting
7-5