Changing Oil Filter - KTM 625 SXC 2003 Owner's Manual

Changing oil filter *

Replace the oil filter when changing the engine oil. Press the foot brake
2
pedal and place a screwdriver or similar between foot brake pedal and
stopper roll so that the oil filter cover is more accessible. Remove banjo bolt
1 and the three screws. Remove oil filter cover 2 and oil filter. Clean the
filter case, oil filter cover and sealing areas. Make sure the oil duct in the oil
filter cover is not clogged.
1
3
Place the new oil filter on the connection in the oil filter cover and mount
4
1 together with a new seal . Tighten the 3 screws in the filter cover to
5 Nm (4 ft.lb). Tighten the hollow screw with seals and tighten to 15 Nm
(11 ft.lb).
Finally, start the engine and check the oil system for leakage.
4
3
2
45