Changing The Engine Oil; Changing And Bleeding The Microfilter - KTM 625 SXC 2003 Owner's Manual

1
3
44
5
7

Changing the engine oil *

The engine oil change is to be carried out when the engine is still warm.
A
A
NOT BURN YOURSELF
Place the motorbike on a horizontal surface. Remove the two plugs (
2
T
2
Clean the plugs thoroughly with a fireproof solvent and compressed air, in
order to remove the metal abrasion. After all the oil has drained through,
clean raised and flat faces and install plugs with seals. Tighten plug
30 Nm (22 ft.lb)and plug
Remove screw connection
engine oil (e.g. Shell Advance Ultra 4).
Start the engine and check all screw connections and the oil filter cover for
leakage.
Check the engine oil level and correct if necessary.

Changing and bleeding the microfilter *

Replace the microfilter while changing the engine oil. To do so, remove
hexagon screws
microfilter, clean its parts and check the O-ring on the microfilter lid for
signs of damage. Before installing the new micro filter, soak it in clean
4
engine oil. Place a new microfilter in the filter housing, apply a thin layer of
grease to the O-ring and mount the microfilter cover.
It is necessary to bleed the micro filter so that all friction areas can be
quickly supplied with engine oil. To do this, fill with oil and remove the jet
screw
the oil filler hole on the clutch cover with a rag. Allow the engine to run at
idle until oil runs out of the oil line
and the jet screw. Torque the jet screw to 10 Nm (7 ft.lb) and check for
leaks.
6
WARNING
N ENGINE HAVING BEEN RUN WARM
.
), and drain oil into a container.
CAUTION
!
A
HE SCREW PLUG MUST NOT BE REMOVED
2
with 20 Nm (15ft.lb).
3
4
and take off the microfilter cover
6
from the oil line on the clutch cover. Start the engine and close off
,
AND THE ENGINE OIL IN IT ARE VERY HOT
, -
THIS IS PART OF THE BY PASS VALVE
on the clutch cover and add 1.5 liters of
5
7
. Turn the engine off. Install seal rings
-
DO
1
and
!
.
1
with
. Remove the