Table of Contents
Advertisement
8
LAP/LAP display mode
The lap number is shown at the top and the lap time in hours, minutes and
seconds at the bottom of the display.
If no lap time is stored or the motorcycle is driving, the LAP/LAP mode will
be skipped.
Hold the MODE button for 3 seconds in the SPEED/LAP mode to clear the
stored lap times.
+
changes to the next lap time.
BUTTON
–
no function
BUTTON
press the MODE
to change to the next mode
BUTTON
press and hold the MODE
BUTTON
SPEED/CLK (clock) display mode
CLK will display time in hours, minutes and seconds.
+
no function
BUTTON
–
no function
BUTTON
press the MODE
to change to the next mode.
BUTTON
press and hold the MODE
BUTTON
(see SETTING THE CLOCK)
SPEED/H (hours) display mode
When you stop driving and no impulses are sent from the wheel sensor, the
display mode will automatically change from SPEED/ODO to SPEED/H. H
shows the operating hours. The operating hour counter starts to count as
soon as you start the engine. The displayed figure cannot be cleared.
Service intervals are indicated in operating hours for some KTM offroad
motorcycles, making the operating hour counter a very practical function.
+
no function
BUTTON
–
no function
BUTTON
press the MODE
to change to the next mode
BUTTON
press and hold the MODE
BUTTON
(see REVEALING/CONCEALING functions).
SPEED/TRP1 (trip 1) display mode
The TRP1 trip meter is always active and counts to 999.9. It is used to
measure the length of a trip or the distance between 2 refueling stops.
TRP1 is linked to AVS1 and STP1. The calculation of these figures is
activated by the first impulse received from the wheel sensor (when the
front wheel starts to turn) and stops 3 seconds after the last impulse is
received (when the front wheel has stopped).
The TRP1, AVS1 and STP1 figures are automatically reset to 0 after passing
999.9.
+
no function
BUTTON
–
no function
BUTTON
press the MODE
to change to the next mode.
BUTTON
press and hold the MODE
TRP1, AVS1 and STP1 figures to 0.
SPEED/AVS1 (average speed 1) display mode
AVS1 is always active and shows the average speed based on the TRP1 and
STP1 figures. The calculation of this figure is activated by the first impulse
received from the wheel sensor and stops 3 seconds after the last impulse is
received.
+
no function
BUTTON
–
no function
BUTTON
press the MODE
to change to the next mode
BUTTON
press and hold the MODE
BUTTON
STP1 figures to 0.
3
to change to the next mode
SECONDS
3
to set the time in the menu
SECONDS
3
to change to the SETUP mode
SECONDS
3
to automatically reset the
BUTTON
SECONDS
3
to reset the TRP1, AVS1 and
SECONDS
Hide quick links:
Advertisement
Table of Contents
