Ip Setup > Static Routes; Time Zone Configuration - Multitech MultiModem rCell MTCBA-H3-EN3-P1 User Manual

Chapter 3 – Using the Web Management Software

Time Zone Configuration

Time Zone:
Time Zone Offset:
Daylight Configuration
Daylight Saving:
Daylight Saving Offset:
Daylight Saving Start Time
Start Ordinal:
Start Month:
Start Day:
Start Time:
Daylight Saving End Time
End Ordinal:
End Month:
End Day:
End Time:
IP Setup > Static Routes
Routing information is used by every computer connected to a network to identify whether it is sending a data
packet directly to the firewall or passing it on to another network. The options to Delete or Edit a route after it has
been defined and added are available by using the table at the bottom of the screen.
Multi-Tech Systems, Inc. MultiModem rCell User Guide
Enter your time zone. Default = UTC (Universal Coordinated Time, Universal Time). See
the following Web site for Time Zone information:
http://wwp.greenwichmeantime.com/info/current-time.htm
Enter +/- hh:mm. Default = +00:00. Offset is the amount of time varying from the
standard time of a Time Zone.
Enables/disables Daylight Saving mode. The default is Enable.
Set the offset to use during Daylight Saving mode. Default is +60 minutes. Enter the
time in + / - minutes.
Set the start ordinal to use during Daylight Saving mode. Options are
first/second/third/fourth/last. Default is second. Daylight Saving time usually starts at
the same time on the same day of the week in the same month every year. Each day of
the week occurs four or five times a month. Therefore, you will be selecting the week in
which daylight saving time starts: the first, second, third, fourth or the last of the
month.
Set the start month to use during Daylight Saving mode. Default is March.
Set the start weekday to use during Daylight Saving mode. Default is Sunday.
Set the start time to use during Daylight Saving mode. Default is 02:00 (hh:mm).
Set the end ordinal to use during Daylight Saving mode. Select the week in which
daylight saving time ends. Options are first/second/third/fourth/last. Default is first.
Set the end month to use during Daylight Saving mode. Default is November.
Set the end weekday to use during Daylight Saving mode. Default is Sunday.
Set the end time to use during Daylight Saving mode. Default is 02:00 (hh:mm).
30