Telnet Configuration; Ip Setup > Http Configuration - Multitech MultiModem rCell MTCBA-H3-EN3-P1 User Manual

Server Port:
Broadcast Timer:
Auto Reboot Timer Configuration
Auto Reboot Timer:

Telnet Configuration

Enables/Disables the Telnet port. The default is Enable. This is specifically for telnet port 23 for technical support
debug. You can still access the integrated cellular modem using port 5000 when this is disabled. Ensure that PPP is
also disabled before telnetting to the port.
IP Setup > HTTP Configuration
HTTP Configuration
HTTP Port:
HTTP Time-out:
Authentication
Username:
Password:
Notes: User name and password are case-sensitive.
Change the password to one that is more secure.
Passwords can be up to 100 characters.
27
Enter the Server Port Number. Default port is 1020.
Enter the amount of time in seconds for the auto-discovery packet granularity of
periodic broadcasting. Default is 10 seconds.
Enter the number of hours to lapse between each automatic reboot. The default of zero
deactivates the timer. Range is 0 to 999.
Enter the port number on which the HTTP server will listen for requests. Default is 80.
Set the HTTP session in seconds. The default is 120 seconds.
Enter the Username that can access to the Web Management software. Default is
admin. This username and password are also used for telnet access to the router and
integrated cellular modem.
Enter the Password for access to the Web Management software. Default is admin.
Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem rCell User Guide