Table of Contents
Advertisement
Chapter 3 – Using the Web Management Software
General Configuration
Date and Time:
IP Configuration
Enter the following addresses for the Ethernet interface.
IP Address:
Mask:
Default Gateway:
Primary DNS:
Secondary DNS:
For more information, see
Auto Dial out Configuration
Auto Dialout:
Raw Dialout:
Auto Dialout Login:
Auto Dialout Port:
Handle EIA Signal:
Inactivity:
Syslog Configuration
Syslog:
Syslog Server IP Address:
Auto Discovery
Auto Discovery:
Multi-Tech Systems, Inc. MultiModem rCell User Guide
The system date and time display in these formats: MM/DD/YYYY / HH:MM:SS. A real
time clock is part of SNTP to display proper time.
Default = 192.168.2.1
Default 255.255.255.0
Default 0.0.0.0
Default 0.0.0.0
Default 0.0.0.0
Appendix A – Commonly Supported Subnets Reference
Check the box to enable/disable Auto Dialout. Default = Enable. The Auto Dialout
settings allow you to use the integrated cellular modem directly with no router
functionality. This is accomplished using redirector software on your pc. This software
creates a virtual serial port allowing your pc to communicate with the integrated
cellular modem over IP using telnet.
Check the box to enable/disable raw mode for an Auto Dialout session. Default =
Disable.
Check the box to enable or disable Auto Dialout Login feature. Default = Enable. The
Auto Dialout port is the telnet port used by the redirector software on your pc to
communicate to the integrated cellular modem.
Enter the serial Auto Dialout Port number. Default = 5000.
Check the box to enable/disable the EIA standard signal characteristics (time and
duration) used between different electronic devices.
Enter the time in seconds that the auto dialout session will stay active before going
inactive.
Check the box to enable or disable Syslog. Default = Disable.
If a Remote Syslog Server IP Address is specified, the syslog feature acts as a remote
Syslog.
heck the box to enable or disable Auto Discovery to broadcast (MAC level), the MAC
Address, IP Address, and DHCP information to the configured server port. Default =
Enable. The router will send a broadcast packet on the specified server port every 10
seconds or whatever interval the broadcast timer is set to.
Table.
26
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiModem rCell MTCBA-H3-EN3-P1 and is the answer not in the manual?