Advertisement
Available languages
Available languages
Psi@petite C ctb n® Ope
Ii
_ III
I
I
"
,,,
Ii
s,,>,
_,
Ut / r#' Hoo< ps
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
GROUNDING
INSTRUCTIONS
• For a grounded, cord-connected
dishwasher:
The dishwasher
must be grounded.
In the event of a
malfunction
or breakdown,
grounding
will reduce the
risk of electric shock by providing
a path of least
resistance
for electric current. The dishwasher
is
equipped with a cord having an equipment-grounding
conductor
and a grounding
plug. The plug must be
plugged
into an appropriate
outlet that is installed and
grounded
in accordance
with all local codes and
ordinances.
WARNING:
Improper connection
of the
equipment-grounding
conductor
can result in a risk of
electric shock. Check with a qualified electrician
or
service representative
if you are in doubt whether the
dishwasher
is properly grounded.
Do not modify the
plug provided with the dishwasher;
if it will not fit the
outlet, have a proper outlet installed by a qualified
electrician.
• For a permanently
connected
dishwasher:
The dishwasher
must be connected
to a grounded
metal, permanent
wiring system, or an equipment-
grounding
conductor
must be run with the circuit
conductors
and connected
to the equipment-
grounding
terminal or lead on the dishwasher.
SAVE THESE INSTRUCTIONS
Install Electrical
Connection--Direct
Wire Method
1. Drill a 3/4"(1.9 cm) hole in the right-hand cabinet side, the rear
or floor of opening.
A
B
2=
3.
A. Optional locations
B. Preferred locations
If the cabinet is wood, sand hole until smooth. If the cabinet is
metal, cover the hole with a grommet (not provided).
Route cable from power supply through cabinet hole (cable
must extend to the right front side of cabinet opening). Tape
cable to the floor 6" in front of unit. This will prohibit cable
from moving when dishwasher is moved into cabinet opening".
Install Electrical Connection-- Power Supply Cord
Method
NOTE: A mating, 3 prong grounded outlet is required in a cabinet
next to the dishwasher opening.
1. Drill a 3/4"(1.9 cm) hole in the right-hand cabinet side, the rear
or floor of opening.
2=
8i
B
/4. up[tonal
Iocalons
B. Preferred
locations
If the cabinet is wood, sand hole until smooth. If the cabinet is
metal, cover the hole with a grommet (Part Number 302797)
included with power supply cord kit.
Advertisement
