Whirlpool WDF550SAAS0 Installation Instructions Manual page 6

A
B
D
E
A. Drain hose-- cut here, if needed
B. Spring- or screw-type clamps
C. Air gap
D. Large spring-type clamp
G F
E.Drain hose
F. Rubber hose connector
G.
Disposal
inlet
H. Drain trap
Connect Drain Hose to Air Gap-- No Waste Disposal
1=
2.
3=
Cut the end of the drain hose, if needed.
NOTE: Do not cut the ribbed section.
Attach the drain hose to the air gap with the large spring-type
clamp.
NOTE: If the drain hose was cut, use 1V2"to 2 " (3.8 to 5 cm)
screw-type clamp (not provided).
Use a rubber hose connector (not provided) with spring- or
screw-type clamps (not provided) to connect the air gap to the
waste tee above the drain trap and at least 20" (50.8 cm)
above the floor.
B
C
E
H _
A. Drain hose-- cut here, if needed
B. Spring- or screw-type clamps
C. Air gap
D. Large spring-type clamp
G F
E. Drain hose
F. Rubber hose connector
G. Waste tee
H. Drain trap
Connect Drain Hose to Waste Disposal--No Air Gap
1. Remove the waste disposal knockout plug.
NOTE: Do not cut the end of the drain hose.
2. Attach the drain hose to the waste disposal inlet with the large
spring-type clamp.
This connection must be before the drain trap and at least
20" (50.8 cm) above the floor.
NOTE: It is recommended that the drain hose be looped up
and securely fastened to the underside of the counter.
A
B
C
E
A. Large spring-type clamp C. Disposal inlet
B. Drain hose D. Drain trap
Connect Drain Hose-- No Waste Disposal or Air Gap
1. Cut the end of the drain hose, if needed.
NOTE: Do not cut the ribbed section.
2=
Attach the drain hose to the waste tee with the 11/2"to
2" (3.8 cm to 5 cm) screw-type clamp (not provided).
This connection must be before the drain trap and at least
20" (50.8 cm) above the floor.
NOTE: It is recommended that the drain hose be looped up
and securely fastened to the underside of the counter.
A
E
A. Drain hose--cut here, if needed
B. Screw-type clamp
C. Drain hose
B
D. Drain trap
E. Waste tee
6