Recessed Area And Closet Installation Instructions; Maintenance Instructions - Whirlpool YCEP2760KQ0 Installation Instructions Manual

Recessed area and
closet installation
instructions
This dryer may be installed in a
recessed area or closet, For recessed
area and closet installations,
minimum clearances can be found
on the serial tag on the dryer,
The installation spacing is in inches
and is minimum allowable, Additional
spacing should be considered for
ease of installation, servicing and
compliance with local codes and
ordinances,
If closet door is installed, the minimum
unobstructed air openings in top and
bottom is required, Louvered doors
with equivalent air openings are
acceptable,
Companion appliance spacing
should be considered,
The dryer must be exhausted
outdoors.
No other fuel-burning appliance may
be installed in the same closet.
Minimum Installation Clearances
°i0
IS"
(_.] crn)**
III I
a" (0 cm)*
14"
_.6 c_
max.
c_
a"_cm)*
n
c-
(0crn)*
_]. o.6cm)
Recessed Closet
front view side view
Clawt door ..._._ _ 3" (1.6 crn)
48" r,Cl.**
0
3" 0.6 cm)
Closet
front view
• Additional clearances for wall, door and floor
moldin may be required or if external
exha_ll_w is used.
** Openinlg is minimum for closet door. Louvered
door with equivalent air opening is
acceptable.
Maintenance
instructions
• Clean lint screen after each cycle,
• Keep dryer area clear and free from
combustible materials, gasoline and
other flammable vapors and liquids,
• Do not obstruct the flow of
combustion and ventilation air,
Moving the d er
to a new locatlon...
Slide dryer onto cardboard or
hardboard before moving across floor
to avoid damaging floor covering.
Gas dryer models:
• Disconnect electrical cord, Tape
securely to dryer,
• Shut off the gas supply valves in the
gas supply line,
• Disconnect gas pipe and fittings
from dryer and cap gas supply line,
Tape end of dryer gas pipe,
Electric dryer models:
• Shut of electrical supply to dryer,
• Disconnect the power supply cord
or cable from the dryer terminal
block,
All models:
• Make sure leveling legs are secure
in dryer base,
• Tape drum to front panel,
• Tape dryer door, lint screen and
end of gas pipe,
Before the appliance is removed from
service or discarded, remove the
door to the dryer compartment.
If dryer does not
operate properly...
Check the tallowing to be sure that:
I, Electric supply isconnected,
2, Circuit breakers are not tripped or
house fuses blown,
3, Door is closed,
4, Controls are set in a running or
"ON" position,
5, Start button has been pushed
firmly,
6, For gas dryers, check that gas
supply shutoff valves are set in
open position,
If you need
assistance...
The Whirlpool Consumer Interaction
Center will answer any questions
about operating or maintaining your
dryer not covered in the Installation
Instructions, The Whirlpool Consumer
Interaction Center is open 24 hours
a day, 7 days a week, Just dial
1-800 NO BELTS(1-800-662-3587) --
the call is free,
When you call, you will need the dryer
model number and serial number,
Both numbers can be found on the
serial-rating plate located on your
appliance,
Page 12