Recessed And Closet Installation Instructions - Whirlpool Gas dryer Installation Instructions

Recessed and closet
installation
instructions
Fire/Health Hazard
l
Exhaust the dryer to the outslde to prevent
exposure to substances In the gas tuels
and combustion by-products which may
be harmtul to your health.
l
It dryer Is Installed In a closet, the dryer
MUST be exhausted outslde.
Failure to do so may result In a tire or health
hazard.
The following installation spacings and door air
openings for the dryer are possible when
installed and exhausted as noted. (Spacing as
indicated is in inches and is minimum
allowable. For ease of installation and service,
additional spacing should be considered.)
l-l-
o 0
Recessed front view
4s
sq. in.**
0
4
24
sq. in.**
t
Closet door
TO
PREVENT LARGE AMOUNTS OF LINT AND
MOISTURE FROM ACCUMULATING, TO MAINTAIN
DRYING EFFICIENCY AND TO PREVENT EXPOSURE
TO POSSIBLE HEALTH HAZARDS, THIS MACHINE
MUST BE EXHAUSTED OUTDOORS.
Companion appliance spacings should be
considered.
Detailed space requirements can be found on
the label located on the back panel of dryer.
NOTE: No other fuel-burnlng appliance may be
Installed In the same closet.
L
3"
t
14"
4
max.
.
Closet installation -
side view
* Additional clearances for wall, door and floor moldings
may
be required.
** Opening is minimum
for closet door. Louvered door with
equivalent air openings is acceptable.
l
** Additional space is needed when external exhaust elbow is used.
If dryer does not
operate properly...
Before calling for service, check to be sure that:
A. Electrical supply is connected.
8, The
house fuse has not blown or
circuit breaker has not tripped.
C. Door is closed.
D. Controls are set in a running or "ON" position.
E. Start button has been pushed firmly.
F. Gas supply line shutoff valve is open.
When moving the
4
dryer.. .
l
Disconnect the power supply cord and tape
securely to dryer.
l
Shut off the gas supply valve controls in thegas
supply line.
l
Disconnect gas pipe fillings from dryer and cap
the gas supply line.
l
Unscrew the cable bracket from the wall stud or
concrete wall. Save the bracket and four screws.
l
Tape the drum to the front panel. Tape the dryer
door, lint screen lid and end of dryer gas pipe.
l
Turn leveling legs all the way in.
Before installing your dryer in your new home,
check with your gas supplier or dealer to see that
your dryer is equipped with the correct burner for
the particular type of gas in your new home.
Burner information may be found on the
serial/rating plate located In the door well of the
dryer.
If vou need
as&stance...
Check your Use and Care Guide for a toll-free
number to call or call the dealer from whom you
purchased this appliance. The dealer is listed in
the Yellow Pages of your phone directory under
"Appliances - Household - Major - Service
and Repair." When you call, you Will need the
dryer model number and serial number. Both
numbers are on the serial/rating plate located in
the door well behind dryer door and on front of
opening.
Printed on recycled paper.
10% post consumer waste/
50% recovered materials.
Part No. 3395337 Rev. A
01994
Benton Harbor, Michigan 49022
Printed in USA,