Maintenance - JVC UX-DM8 Instructions Manual

Editing operations
(see pages 28 to 33)
• Do not vibrate the System while recording/editing tracks.
Take care especially while "WRITING" is shown on the
display. It may damage the recorded tracks in the System.
Giving (Editing) Titles to Tracks or Groups:
• When a track is recorded, the track title is given to the track
automatically. When you give a title to the track, delete
that title first, then enter your desired title.
Erasing a Group (ERASE GR):
• When deleting a group including unplayable track from the
USB device, only the playable tracks are deleted, and the
unplayable tracks remains (the group cannot be erased).
• When deleting a group including more than 999 tracks on
the USB device, only the tracks recognized by the System
are deleted (the group cannot be erased).
Timer Operations
(see pages 34 and 36)
• When you unplug the AC power cord or if a power failure
occurs, the timer will be canceled. You need to set the
clock first, then the timer again.
Setting Recording Timer:
• The volume is set to "VOLUME 0" while recording. When
you want to hear a sound while recording, adjust the
volume manually.
Setting Playback Timer:
• If you do not specify the preset station or track number
correctly while setting a timer, the currently selected station
or the first track will be played with the timer activated.
• When Playback Timer works, the volume increases
gradually to the volume you have set.
Timer Priority:
• If you set the Sleep Timer after Recording or Playback
Timer starts, Recording or Playback Timer is canceled.
39

Maintenance

To get the best performance of the System, keep your discs
and mechanism clean.
Handling discs
• Remove the disc from its case by holding it at the edge
while pressing the center hole lightly.
• Do not touch the shiny surface of the disc, or bend the disc.
• Put the disc back in its case after use to prevent warping.
• Be careful not to scratch the surface of the disc when
placing it back in its case.
• Avoid exposure to direct sunlight, extreme temperature,
and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center
to edge.
Cleaning the System
• Stains should be wiped off with a soft cloth. If the System
is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean
with a dry cloth.
• Since the System may deteriorate in quality, become
damaged or get its paint peeled off, be careful about the
following:
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it forcefully.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as
insecticides to it.
– DO NOT allow any rubber or plastic to remain in contact
for a long time.
To remove the speaker grilles:
Holes
Speaker
grille
Projection