Timer Operations; Setting Recording Timer - JVC UX-DM8 Instructions Manual

Remote control
Number
buttons
REPEAT
When you want to activate two or three timers, leave
a blank time of 6 minutes or more between the end
time of the first timer and the start time of the second
timer. If the blank time is less than 6 minutes,
another timer does not work.

Timer Operations

STANDBY/ON
CANCEL
SET
ENTER
4,¢
CLOCK/TIMER
INFO

Setting Recording Timer

You can use Recording Timer to record FM/AM broadcasts
or sounds from a portable audio device to the built-in
memory.
• You can store three timer settings in total of Recording
Timer and Playback Timer (see page 36).
• To exit from the timer setting, press CLOCK/TIMER as
required.
• To correct a mis-entry during process, press CANCEL.
You can go back to the previous step.
How Recording Timer works
When Recording Timer has been set, the
REC indicator and timer number (1, 2, or 3) indicator are
lit on the display.
• Recording Timer starts working only when the System
is turned off (on standby).
When the start time comes
The System turns on, tunes in to the specified source, sets
the volume level to the preset level, and starts recording.
When the end time comes
The System stops recording, and turns off (on standby).
• The timer setting remains in memory until you change it.
1
Prepare the source to record.
• When you want to record the radio broadcast (FM or
AM):
Preset the desired station. (See "To preset the stations"
on page 7.)
• When you want to record the portable audio device:
Connect the portable audio device to the AUX jack (see
page 11), and set the timer on that device.
2 Select "TIMER1," "TIMER2," or "TIMER3."
TIMER1
3 Confirm your selection.
Example: when TIMER1 is selected.
Remote
INFO
ONLY
indicator,
TIMER2
TIMER3
Clock setting
Canceled
Continued on the next page
34