Connecting A Tv - JVC NX-F7 Instructions Manual

NX-F3_NX-F7[A]EN.book Page 8 Tuesday, April 22, 2008 1:55 PM

Connecting a TV

After connecting a TV, follow the instructions on
pages 10 and 11.
■ IMPORTANT
• Connect the main unit directly to a TV (or a mon-
itor) without routing through a video cassette
recorder (VCR). Otherwise picture distortion
may occur during playback. (Routing the con-
nection through a VCR, however, does not affect
the audio quality.)
Main unit VCR
Direct connection
• Connecting the main unit to a VCR-built-in-TV
may also cause picture distortion during play-
back.
Connecting a TV with the [VIDEO]
terminal
TV
To a video input terminal
Composite video cable (supplied)
Connecting a TV with the
[COMPONENT] terminals
TV (or monitor)
Connecting a TV with the [HDMI
MONITOR OUT] terminal
This system can output uncompressed digital
video signals to a TV compatible with HDMI (High
Definition Multimedia Interface).
Main unit
(rear view)
NOTE
• The HDMI video signal type can be checked with
the "HDMI" indicator in the display window.
(Refer to "Selecting the video signal type" on
pages 10 and 11.)
• If the picture is distorted while an HDMI TV is
connected, turn off the main unit and turn it on
again.
• A TV compatible with HDCP (High-Bandwidth
Digital Content Protection) can also be con-
nected to the [HDMI MONITOR OUT] terminal,
so that the uncompressed HD video signal type
can be output as well.
• This system is compatible with some basic func-
tions of HDMI CEC. (Refer to page 51.)
TV
Main unit
(rear view)
To component
input terminals
Component video cable (not supplied)
TV
To an HDMI input terminal
HDMI cable (not supplied)
Main unit
(rear view)
8