Profiles - JabloCom EYE-02 User Manual

MODE
In ENROLL mode, the camera allows new external wireless devices to be
enrolled, such as remote controls, detectors, sirens, etc. A new contact phone
ENROLL
number can also be enrolled in this mode, by simply calling the camera. ENROLL
mode is terminated automatically after one new item has been enrolled.
TEST mode is a special mode for testing the functionality of all detectors without
TEST causing a number of unwanted alarm reports. The camera beeps and blinks after
any of the sensors is activated.
In REPORT mode, the camera sends a special report to all contacts (call, MMS etc.)
according to the camera settings.
REPORT
Example of an SMS from the camera: Camera EYE-02 reports: User originated
camera test External wireless device RC-80(1), Time:13/11/2008 11:33:49.
In this special mode, the camera acts as a standard USB flash disk. It allows access
to files on the SD memory card without a special camera driver being installed on
USB
the PC.
To protect the camera, special modes will be closed automatically after a 5-minute time-out and the camera
will return to CONFIG mode.

3.5 Profiles

The EYE-02 camera offers a fast and simple way of setting all necessary detector parameters by selecting one of pre-
defined profiles. These profiles are suitable for most camera applications. If necessary, the profile may be further
adjusted by the user in JabloTool software or via JabloTool web portal available on
Ꮀ HOME
The HOME profile has been designed for camera installation inside
a building (house, flat, office). During WATCH mode, there are no
movements of people, gusts of wind, significant temperature changes
or loud noises expected.
Ꮀ OUTDOOR
The OUTDOOR is suitable for installation of the camera outside your
home. The camera significantly reduces the sensitivity of the detectors in
OUTDOOR mode because there are many sources which could potentially
cause a false triggering of the alarm - sunshine, animals, street noise, wind,
etc.
For outdoor installation see chapter 5.5.
Ꮀ GARAGE
This profile is suitable for installation inside your garage. It is similar to the
HOME profile. Additionally, the GARAGE profile provides a 30-second
entrance delay. It allows you to open the garage or home entrance door first
and switch the camera to the SLEEP mode during this delay.
Ꮀ CARE
The CARE profile has been designed specifically for monitoring small children
and elderly or disabled people.
Using the camera with the CARE profile allows
the user to leave the home, stay a short distance away
from home and watch their sleeping baby or unwell relative
at the same time. The camera is activated by any movement
or by a PANIC alarm (triggered by a personal wrist button)
EYE-02.ENG.MAN.User_Manual.21
DESCRIPTION
- 7 -
COMMAND
press the and
simultaneously for about 4
seconds
Press the power button
CONFIG mode for 3 seconds
(until camera emits 4 beeps)
www.jablotool.com.
buttons
in
EN