Usage Of The Drain Hose - Haier HWM62-0566 User Manual

How to change the direction of the drain hose
1.Loosen the screws of back cover, dismantle the back cover, then take off the
drain hose(As indicated figure 1)
2.Take off the drain hose from base, nip flat the drain hose mouth, dismantle the
hang hook, take the drain hose into cabinet from the left of base As indicated
figure 2)
3.Extend the drain hose from the right side of base, fix the drain hose onto the base
with the drain hose frame, and screw down the screws, put the hang hole onto the
drain hose ,then hang up the drain hose.(As indicated in Figure 3)
4.Install the back cover as primary state.
Remarks: in order to make sure of the correct of installation, it is suggested to change the
direction of the drain hose with our company serviceman .

Usage of the drain hose

The drain hose shall drain smoothly
1.The height of the drain hose shall be less than 10cm,
or the drainage will not be smooth, and cost such long
time that the machine may stop at mid way.
2.Do not trample or press the drain hose.
3.If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
Figure 1
Drain hose
frame
Figure 2
nip flat the drain hose
mouth, dismantle the
hang hook
Figure 3
4.If extra drain hose is needed, please make
separate purchase. The inner diameter of the
extra hose shall not less than 30mm, and the
length shall not exceed 1.5m.
If the extra hose is too long, cut it either at A
or at B point.
5