Troubleshooting - Bowflex TreadClimber TC20 Owner's Manual

Troubleshooting

Condition/Problem
Unit will not turn on, power switch
does NOT light up
Power switch is lit but display
screen does not turn on
Speed displayed is not accurate
Console displays drive error code
("C", "S", or "H" with a number )
Console displays "LUbE" code
40
Things to Check
Outlet
Power cord not plugged
in
Power switch turned off
Safety key not plugged
in
I/O Cable
If problem persists
Display set to wrong unit
of measure. (English/
Metric)
Unit needs to be
restarted
Error code diagnostic
Belt lubrication
Solution
Make sure outlet is functioning correctly. Verify
this by plugging another device (ex: lamp) into
the outlet. If outlet is connected to a light switch,
check to make sure it is on. If outlet is not
functioning fi nd a working outlet.
Make sure the power cord is fi rmly secured to
A/C inlet on the unit and fi rmly inserted into a
non-GFI wall socket.
Make sure the power switch at the rear of the
unit is in the "ON" position. Switch will light up
red to indicate power is present.
Plug Safety Key into Console (See Safety Key
- Emergency Stop Procedures within Features
section).
Check I/O Cable connections at back of con-
sole. If display still will not light up, replace I/O
Cable.
Contact Customer Service.
Change display units.
Cycle power off for 10 seconds using power
switch at rear of unit, then restart.
Contact Customer Service.
Consult lubrication schedule and apply if neces-
sary. Push START button.