Walking Belt Alignment - Bowflex TreadClimber TC20 Owner's Manual

Adjusting the Walking Belts – While operating the machine, notice where the belts run on each Treadle. The
Walking Belt Adjustment Bolts are on the front end of each Roller. If the belt is tracking too far to the right, use a
properly sized Hex Key to turn the right adjustment bolt clockwise on that belt in full turn increments. If the belt
tracks too far to the left, do the same thing on the left adjustment bolt.
Note: Do not turn the bolts counterclockwise when you adjust the belt alignment.
Belt Tension Check – Check the belt tension only when the machine is unplugged. From the belt's midpoint,
a correctly tensioned belt should only have an inch of give. To check, pull the belt upward at its midpoint and
measure the distance to the deck. If the distance is more than an inch, the belt is loose. To tighten, turn both
Walking Belt Adjustment Bolts clockwise one-half a turn and check tension again. Repeat this step if necessary.
Note: Bolts are turned counterclockwise equally to decrease belt tension.
Walking Belt Adjustment Walking Belt Adjustment
Bolts Bolts
Maintenance
35