Innova 31603 Owner's Manual page 67

1. While linked to the vehicle, start the engine, then press and release
the
The "Mode Selection Menu" displays.
2. Use the UP
buttons, as necessary, to highlight Live
Data, then press the ENTER
The "Live Data" menu displays.
3. Use the UP
buttons, as necessary, to highlight
"Record Live Data", then press the
ENTER
4. Use the UP
buttons, as necessary, to highlight
"Record by DTC trigger", then press the
ENTER
If DTCs are presently stored in the
vehicle's
message displays. Use the UP
and
necessary, to highlight Erase DTCs,
then press the ENTER
erase DTCs from the vehicle's
computer. When the Erase process
is complete, the "Record by DTC
Trigger" screen displays.
5. When the "Record by DTC Trigger"
screen displays, select the desired
trigger point as follows:
The Scan Tool is capable of recording approximately 100 frames
of Live Data. Record by DTC trigger lets you select the point in
time at which you wish the Scan Tool to begin recording Live Data.
You can set the trigger point to record the 100 frames of data
before an event (when the DTC sets), after the event, or in the
middle (50 frames before and 50 frames after the event.
Beginning - records approximately
100 frames of Live Data after the
DTC sets.
Middle - records approximately 50
frames of Live Data before and 50
frames after the DTC sets.
End - records approximately 100
frames of Live Data before the DTC
sets.
OBD2
button.
and DOWN
and DOWN
button.
and DOWN
button.
computer, an
DOWN buttons,
Live Data Mode
RECORDING (CAPTURING) LIVE DATA
button.
advisory
as
button to
65