Innova 31603 Owner's Manual page 54

Using the Scan Tool
VIEWING SRS DTCs
If the vehicle does not support SRS
communication, an advisory message
shows on the Scan Tool's display.
Press the
Enhanced Main Menu.
3. To read the display:
Refer to DISPLAY FUNCTIONS on page 8 for a description of
LCD display elements.
A visible
through the vehicle's DLC connector.
A visible
(communicating with) the vehicle's computer.
The upper right hand corner of the
display shows the number of the
code currently being displayed, the
total number of codes retrieved.
The Diagnostic Trouble Code (DTC)
and related code definition are
shown in the lower section of the
LCD display.
I/M MONITOR STATUS icons are not displayed when viewing
SRS DTCs.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information. Use the UP
additional information.
The Scan Tool will display a code only
if codes are present in the vehicle's
computer memory. If no codes are
present, a "No SRS DTC's are pres-
ently stored in the vehicle's computer"
is displayed. Press the
to return to the Enhanced Main Menu.
4. If more than one code was retrieved press the
necessary, to display additional codes one at a time.
Whenever the Scroll function is used to view additional codes,
the Scan Tool's communication link with the vehicle's computer
disconnects. To re-establish communication, press the POWER/
LINK
5. When the last retrieved DTC has been displayed and the
button is pressed, the Scan Tool returns to the Enhanced Main Menu.
To exit the enhanced mode, press the
Tool returns to the DTC screen.
52
button to return to the
icon indicates that the Scan Tool is being powered
icon indicates that the Scan Tool is linked to
and DOWN
button again.
buttons, as necessary, to view the
button
button, as
button. The Scan
OBD2