Table of Contents
Advertisement
Begin Time (minute)
[xx] = begin minute 0 to 59
b : xx
[*] = continue
[#] = return to previous prompt
Begin Day
[xx] = begin day 01 to 17
xx : bd
[*] = continue
[#] = return to previous prompt
End Time (hour)
[xx] = begin hour 00 to 12
xx :
[*] = continue
[#] = return to previous prompt
End Time (am/pm)
[0] = end time, am (A)
[1] = end time, pm (P)
[*] = continue
[#] = return to previous prompt
End Time (minute)
[xx] = end minute 0 to 59
: xx
[*] = continue
[#] = return to previous prompt
End Day
[xx] = end day 01 to 17
xx : d
[*] = continue
[#] = return to previous prompt
Device Number
[xx] = device number 1 to 8
x : dn
[*] = continue
[#] = return to previous prompt
Scheduling User Interface
If the value programmed in the Event Identifier is "3", "4",
or "5", and the current entry is completed, the system will
save all field data up to this field. The system will beep four
times and go back to the first field (Schedule Number) with
the schedule number advanced.
If the value programmed in the Event Identifier is "1" or
"2", and the current entry is completed, the system will
advanced to the next programming field - End Time (hour).
Note: See figure 2 for the definition of begin day entries.
The end hour is a two-digit entry. To enter the hour 3, press
"0" followed by "3".
The end hour "00" indicates this schedule does not have a
end time.
Press "0" to select AM or "1" to select PM.
Note: See figure 2 for the definition of end day entries.
If the event identifier is set to "2" upon completion of this
field, the current schedule data will be saved and the system
will go back to the next schedule number.
[*] will accept and save the entire schedule event. The system
will beep four times and go back to the beginning of the
programming field (Schedule Number) with the schedule
number advanced. If the current schedule number is 8, the
system will wrap around and set the schedule number to 1.
Note: For X-10 devices.
– 25 –
Advertisement
Table of Contents
