Table of Contents
Advertisement
General Information
Before arming your system, all protected doors, windows, and other protection zones
must be closed or bypassed (see the BYPASSING PROTECTION section). Pressing the
STATUS
system condition, making it easier for you to secure any open zones.
READY LIGHT: The green READY indicator on the keypad will be lit if the system is
ready to be armed. If blinking, the system is not ready.
Press the STATUS Key
Press the
phrases may be heard depending on the current state of the system:
disarmed, ready to arm [message] [check system]
disarmed, [not ready to arm], [message]
armed [away] [stay] [instant] [check system] [message]
NOTE: Phrases in brackets are variable, and are announced only if appropriate in the
current state of the system
Press the
may be heard depending on the current state of the system:
fire alarm [zone voice descriptors]
alarm [zone voice descriptors]
fire fault [zone voice descriptors]
fault [zone voice descriptors]
low battery [zone voice descriptor]
system low battery
check system
AC loss
zones bypassed
chime
† (second press must be within 5 seconds of first press)
VOLUME LEVEL: The volume level of system announcements can be increased or
decreased. Refer to the MESSAGE RECORDING/PLAYBACK section for the procedure.
System Can Be Armed
The READY light will be lit once all protection zones have been closed or bypassed.
You may now arm the system as usual.
key will announce all zones that are faulted, as well as any other abnormal
key once to announce the general status of the system. The following
STATUS
†
key twice
to announce specific system status. The following phrases
STATUS
– 11 –
Checking System Status
Advertisement
Table of Contents
