5.1
Basic
Settings
Position Setting
5.1.6
Post Inserter
When the Post Inserter PI-505 is installed on the Finisher FS-526, you can manually operate the Finisher
FS-526 using the post inserter control panel.
Reference
-
Only the lower tray can be used as the output tray. The upper tray is not available.
Keys on control panel
No.
Name
1
Corner staple lamp
2
Center staple & fold lamp
3
[Finishing] key
4
2-hole lamp
5
3-hole lamp
6
[Select punch] key
7
[Start/stop] key
8
4-hole lamp
9
Tri-fold lamp
10
2 position staple lamp
VL6522c/VL5522c/VL4522c
Configure desired staple or hole-punch positions.
Select Auto, and the machine automatically judges the staple or punch posi-
tions for the paper relative to the original direction loaded.
•
A staple or hole-punch position is set along the long side of the paper if the
original length is 297mm or less.
•
Staple or hole-punch positions are set along the short side of the paper if
the original length is more than 297mm.
•
Staple or punching positions are set on the upper or left-side end.
•
Be sure to load the original so that its top side is placed in the back.
•
If desired, press [Original Direction], and then select the original direction.
5
5-13