Memory Scan; Priority Scan - Standard Horizon HX380 Owner's Manual

ceiver will revert to the channel you were prior to switching to the Preset
channel mode.

6.7 MEMORY SCAN

The HX380 is factory default setting is to scan channels stored in Preset memory
bank. You may change the scan range to the all marine channels instead of
the Preset channels via the Menu ("Set") Mode. Refer to Menu Mode Item
"SCAN TYPE" on page 26 for details.
When an incoming signal is detected on one of the channels during scan, the
radio will pause on that channel, allowing you to listen to the incoming trans-
mission. The radio will automatically start scanning again after the transmis-
sion stops.
1. Press the [ PRESET ] key to change the transceiver to the Preset channel
mode.
2. Press the [ SCAN ( DW )] key briefly to start scanning. The scan proceeds
from the lowest to the highest programmed Preset channel and stops scan-
ning when a transmission is received. Scanning will
resume when the incoming signal disappears at the
end of the transmission. The "MSCAN" notation will ap-
pear at the upper left corner of the display during scan-
ning.
3. To stop the scan, press the [ SCAN ( DW )] key briefly.

6.8 PRIORITY SCAN

The Priority Scan is similar to the Memory Scan. However, the Priority Scan
scan the Preset memory channels and the Priority channel. The following chan-
nels can be set as the Priority channel: CH16, CH9, and one of the Preset
channel (default setting is CH16).
1. To set the priority channel, hold down the [ 16/9 ] key and press the
[ H/L ( )] key. The channel will change from 16 to 09 to Preset channels 0
through 9 with each press of the [ H/L (
the [ 16/9 ] key is released the displayed channel will be
set as the priority channel (the "PRI" icon will appear at
the above of the channel number).
2. For priority scanning, press the [ PRESET ] key to change the transceiver
to the Preset channel mode, then press the
[ SCAN ( DW )] key briefly to start the normal (memory)
scanning. Hold down the [ SCAN ( DW )] key. Scanning
will proceed between the Preset channels and the pri-
ority channel. The priority channel will be scanned af-
HX380
)] key. When
Page 21