Powerline PHG-1000X Owner's Manual page 26

PHG-1000X
STEP 5
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
5A. attach fly rod (AA) and fly frame (I) to top frame (D)
using:
2 - (#7) M8X12mm hex head bolt
2 - (#16) M8 washer
5B. insert foam rollers and end caps onto left fly frame (J)
and right fly frame (K) using:
2 - (#35) 4"X10" foam roller
2 - (#25) 38X38mm end cap
5C. insert a rubber grip onto each handle (M) using:
2 - (#33) 25X135mm rubber grip
5D. attach handles (M) to left fly frame (J) and right fly
frame (K), making sure they face inward, using:
2 - (#13) M10 nylon lock nut
2 - (#15) M10 washer
5E. attach left fly frame (J) and right fly frame (K) to fly
frame (I) using:
2 - (#6) M10X16mm hex head bolt
2 - (#15) M10 washer
5F. insert end caps into each end of fly frame (I) using:
2 - (#23) 50X50mm end cap
© Best Company srl
26