Powerline PHG-1000X Owner's Manual page 20

PHG-1000X
STEP 2
BE CAREFUL TO ASSEMBLE ALL COMPONENTS
IN THE SEQUENCE THAT THEY ARE PRESENTED.
NOTE:
finger tighten all hardware in this step. DO NOT wrench tighten
until the last step. some components may be pre-assembled.
nylon lock nuts will not fully screw onto bolts, must wrench tighten.
2A. attach angled frame (C) to leg frame (F) using:
2 - (#4) M10X70mm hex head bolt
2 - (#15) M10 washer
2 - (#13) M10 nylon lock nut
2B. attach angled frame (C) to mainframe (A) using:
2 - (#10) M10X70mm carriage bolt
2 - (#13) M10 nylon lock nut
2C. attach back pad (X) to angled frame (C) using:
2 - (#9) 5/16"X2 3/4" hex head bolt
2 - (#17) 5/16" spring washer
2 - (#16) 5/15" washer
2D. attach top frame (D) followed by flat plate (Z) to
angled frame (C) using:
2 - (#4) M10X70mm hex head bolt
2 - (#13) M10 nylon lock nut
2E. attach lat holder (E) to top frame (D) using:
2 - (#6) M10X16mm hex head bolt
2 - (#15) M10 washer
2F. insert round end cap (#26) into hole end of stopper
rod (W) and rubber stopper (#30) onto opposite end.
insert stopper rod (W) into round slot of angled
frame (C).
© Best Company srl
20