Scenario 4 - Sending A Text Email Using No Configuration - Multitech MultiConnect User Manual

Scenario 4 – Sending a Text Email Using No
Configuration
The to-address, cc-address, and subject are NOT configured in this example.
Issue the following command:
send-mail
The SMTP session then enters into interactive mode requesting the to-address, cc-address, subject
and the message body to be entered. After entering a message, type Ctrl+D to end the message.
The email is sent only to the entered to-addresses (if any) and cc-addresses (if any). The subject and
message body are taken as given in the interactive mode.
Notes:
1. The email is sent only to addresses entered in interactive mode.
2. If the subject is already configured using set command, it will be taken as the subject for the
email.
3. Type Ctrl+C to quit the email at any given time.
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
Chapter 13 – SMTP Client
148