Table of Contents
Advertisement
Autorepeat Recording
Autorepeat Recording
The same tape can be recorded over many times. Please
note that if you activate this feature you will lose the
entire previous recording.
1
Press the Menu, SHIFT
sequence to display the REC MODE SET menu.
• If during autorepeat
recording there is an
alarm trigger, "
" is
2
Press the SHIFT
displayed on the display
panel and alarm
(
recording will take place.
3
Press the SHIFT
Autorepeat recording will
continue after alarm
autorepeat recording mode.
recording has completed
NO . . . . . . Autorepeat recording doesn't take place.
its programmed duration.
YES . . . . . Autorepeat recording takes place.
4
Press the Menu button two times, the normal screen
is displayed.
• The setting procedure is now complete.
5
Press the REC button.
• Recording will start. When the tape's end is reached,
the VCR will rewind it to the beginning regardless of
the counter memory, and recording will resume.
24
, SHIFT
button in
button to make the arrow mark
) point to Repeat Rec Set.
button to set the desired
"R.REC" will light on the display panel.
960-Hour Time Lapse Video Cassette Recorder
Normal Playback
Normal Playback
1
Turn on the power to the TV monitor.
2
Load the video cassette tape.
3
Press the REC/PLAY SPEED
• A slow motion effect or
select the playback speed.
accelerated playback
effect can be achieved by
• The selected playback speed is displayed on the display panel.
using a slower or faster
• A tape recorded with SP heads can be played in 2 / 12 /
playback speed than the
24 / 36 / 48 / 72 / 96 / 120 / 168 / 240 / 360 / 480 / 720
speed used for recording.
/ 960 Hour.
4
Press the PLAY button.
• Playback starts.
• If necessary, adjust the tracking to eliminate the noise
from the picture.
5
To stop playback, press the STOP button.
• To advanced or rewind the tape, press the FF/CUE or
REW/REVIEW button.
Tracking Control
If there is noise in the image during playback,
1
While looking at the playback picture, press and
hold the TRACKING + button to minimize the noise.
2
If it cannot be minimized, press the TRACKING -
button.
3
Press the PLAY button in the playback mode.
Audio Playback
Audio playback is only possible in 2-hour, 12-hour and
24-hour modes.
The playback speed has to be the same as the recording
speed, for normal playback of the audio.
• Noise will appear in the
image when audio
For a tape recorded in 2-hour, 12-hour, and 24-hour
playback is used in
modes, to playback the audio, press the AUDIO ON
12/24-hour mode.
button after pressing the PLAY button. "A" will be
displayed to the left of the playback speed on the display
panel. Press the AUDIO ON button again to remove "A".
960-Hour Time Lapse Video Cassette Recorder
(or
) button to
25
Advertisement
Table of Contents
