Perlick Signature Series Use And Care Manual page 10

18” shallow-depth series beverage center/48” signature series refrigerator / wine reserve stacked on a 48” signature series freezer / refrigerator drawers
Hide thumbs Also See for Signature Series:
Table of Contents

Advertisement

Problem
Compartments are warmer than
usual.
System runs for a long period of
time.
Condensation forms inside the
compartments.
Condensation forms on the
outside of the unit.
For Product Information
Contact your selling dealer.
Inquire via the web at www.perlick.com.
Call 800-558-5592 for factory assistance on
planning installation or product information.
Write to Perlick Corporation, Customer
Service Department, 8300 West Good Hope
Road, Milwaukee, WI 53223.
Email us at warrantyserv@perlick.com.
For Product Service
Check the model and serial number of your
unit located on the label attached to the inside
top of the cabinet.
Inquire via the web at www.perlick.com, or call
800-558-5592.
Printed in USA
Cause
- Control preset is set to warm.
- Light is staying on.
- Condenser is dirty or obstructed.
- The door is open or has been opened
more frequently lately.
- Internal louvers and/or the fan guard
is obstructed.
- Warm product was recently placed in
the cabinet.
- Condenser is dirty or obstructed.
- Door was kept open for a long time or
was opened more frequently, or warm
product was recently placed in the
cabinet.
- Hot day and warm room temperature.
- High humidity and/or frequent door
opening.
- Door not closing and sealing properly.
- High humidity and/or frequent door
opening.
- Door is not closing and sealing
properly.
10
- Lower the setpoint temperature. Refer to
changing the setpoint for the specifi c model.
- Turn the manual light switch off.
- Clean the condenser and clear obstruction.
- Wait 24 hours and recheck the temperature.
- Reset the preset temperature if necessary -
refer to page 4 of this guide.
- Make sure the louvers and/or the fan are
not obstructed.
- Wait 24 hours for product to chill, then
recheck the temperature.
- Clean the condenser and clear obstruction.
- Wait 24 hours and recheck temperature.
- Normal for the system to run more
frequently.
- Normal operation.
- Make sure the door is closing properly.
Check the door seal and replace it if
necessary.
- Normal operation.
- Make sure the door is closing properly.
Check the door seal and replace it if
necessary.
- If condensation persists, contact Perlick
Technical Service at 800-558-5592.
For Replacement Parts and Accessories
Use only genuine Perlick replacement parts
and accessories. Genuine Perlick parts and
accessories are designed to work correctly
with Perlick products and offer superior
service life. The use of non-Perlick parts can
damage the unit and may void the warranty.
Check the model and serial number of your
unit located on the label attached to the inside
top of the cabinet. Call your Perlick Factory
Authorized Service Center.
Inquire via the web at www.perlick.com, or call
800-558-5592.
Use and Care Guide
Solution
0213

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Signature Series and is the answer not in the manual?

Table of Contents