Mending And Darning - Husqvarna Viking Prelude 350 User Manual

Sewing
Zigzag
The zigzag is utilized for sewing on lace,
bound edging and appliqués.
The zigzag width will be decreased from the left
5.5 mm width, steplessly to the right to 0 mm.
In this position the machine sews straight stitch
in the right needle position. Experiment until you
reach the best setting for your actual work.
Three-step Zigzag
Overcasting
Three-step zigzag is suitable for overcast-
ing most fabrics. Trim the edges of the fabric
before overcasting.
Make sure that the needle sews over the edge
of the fabric. Place the fabric according to the
presser foot (see picture).

Mending and Darning

Three-step zig-zag , can be utilized for
mending and darning. A threadbare spot is
mended by sewing back and forth with three-step
zig-zag.
Use the reverse and for every row of stitching,
guide the fabric slightly to the side. If the fabric
is very worn, a piece of fabric or lining may be
attached to the reverse side of the material as
reinforcement.
22