Connecting The Foot Control; Connecting To The Power Supply - Husqvarna Viking Prelude 350 User Manual

Connecting the Foot Control

Among the accessories you will fi nd the foot con-
trol cord and the main cord.
1. Remove the foot control cord. Place the foot
control on its narrow side. Fit the plug into the
socket inside the foot control compartment.
2. Push it fi rmly to make sure it is properly
connected. This operation is only necessary
the very fi rst time you are going to use the
machine.
3. To correctly turn away the cord, place it into
the slot.
Note: Before plugging in, check to ensure that
the foot control is of type "FR4".
Connecting to the Power
Supply
On the underside of the machine you will fi nd
information about the power supply (V) and the
frequency (Hz). Check the power supply setting
in the machine to ensure that this agrees with the
main supply before you connect the machine.
1. Connect the foot control cord to the fi rst
socket on the bottom right side of the
machine.
2. Connect the main cord to the back socket on
the bottom right side of the machine.
3. When you press the power switch, both the
machine and the light are switched on.
For the USA and Canada
This Sewing Machine has a polarized plug (one
blade wider than the other). To reduce the risk
of electric shock, this plug is intended to fi t in a
polarized outlet only one way. If the plug does
not fi t fully in the outlet, reverse the plug. If it
still does not fi t, contact a qualifi ed electrician to
install the proper outlet. Do not modify the plug
in any way.
4
Procedures
3. 1. 2.