Electrolux EIMGD60LT3 Installation Instructions Manual page 19

Reversing Door
Preparing to
1
2
3
4
reverse door swing
Be sure you have adequate swing area before reversing door.
You will need a screw driver with a #2 square bit.
Protect flat work surface, such as top of dryer or floor near dryer,
with a soft cloth or towel.
Be sure dryer is unplugged from power source!
Tools needed:
Screwdrivers with
#2 square &
straight bit
Removing door and hardware
A) Removing Trim Ring
1 Open door to 90 degree angle.
2 Remove and save trim plug and long,
course-thread, panhead screw.
B) Removing Door from Hinge
1 Reopen door to 90 degree angle.
2 Remove 4 long, course-thread, counter-sunk
hinge screws from door.
3 Close door.
4 Rotate door trim approximately 3A"counter-
clockwise and pull ring away from door.
\
3
4
While supporting the weight of the door
with both hands, separate the door from the
hinge.
Gently place door face down on flat, covered
work surface.