Range Installation - Frigidaire FES367AQC Installation Instructions Manual

30" electric slide-in range
Hide thumbs Also See for FES367AQC:
Table of Contents

Advertisement

Available languages

Available languages

5. Range Installation
When unpacking the range, do not
discard the 4 shipping bolts. These are to be replaced on
the unit for use as leveling legs and height adjustments.
.
Installation
Without
Side Panel(s)
A.
The range cooktop overlaps the countertop
at
the sides and the range rests on the floor. The
cooktop is 30" (76.2 cm) wide.
B.
Install base cabinets 29" (73.7 cm) apart. Make
sure they are plumb and level before attaching
cooktop. Shave raised countertop
edge to clear
30" (76.2 cm) wide range top rim.
C.
Install cabinet doors 31 " (78.7 cm) min. apart so
as not to interfere with range door opening.
D. Cutout countertop exactly as shown on page 1.
E. A backguard kit can be ordered through your
dealer.
F. Adjust leveling legs so that the underside of the
cooktop is sitting on the countertop.
G.
Level the range. The floor where the range
is to be installed
must be level (see Figure 9).
.
Installation
With Side Panel(s)
A.
Install base cabinets 30 1/8" (76.5 cm) min.
apart. Make sure they are plumb and level.
B.
Install cabinet doors 31 " (78.7 cm) min. apart so
as not to interfere with range door opening.
c.
A backguard kit can be ordered through your
dealer.
D
An end panel kit can be ordered through your
dealer.
E.
Level the range and adjust cooktop height.
3.
Installation With Backguard
The cutout depth of 21 5/8" (55 cm) needs to be
increased to 24" (61 cm) when installing a backguard.
6. Leveling
the Range
Level the range and set cooktop height before
installation
in the cut-out opening.
1.
Install an oven rack in the center of the oven.
2.
Place a level on the rack. Take 2 readings with the
level placed diagonally in one direction and then the
other. Level the range, if necessary, by adjusting the
4 leg levelers with a wrench (see Figure12).
3.
Taking care to not damage the countertop,
slide
range into cut-out opening and double check for
levelness. If the range is not level, pull unit out and
readjust leveling legs, or make sure floor is level.
Figure 9
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents