GE ZDP484NG Installation Instructions Manual page 22

Installation Instructions for Gas Conversion
[_ CHANGE BURNER ORIFICES {cont.}
IMPORTANT: Find your model number below. Read
each orifice label to identify and install them in the
exact locations shown.
ZDP304 SIMMER ORIFICES
A 34SL or 52SN orifice
will be used on ell burners.
ZDP304 MAIN ORIFICES
tt_LN°rorifice I/1OO) J I_,_y _ d
will be used
on these three
burners.
Use a 108XL
or 190XN orifice
forthe right
front burner.
ZDP364, ZDP366, ZDP484, ZDP486
SIMMER
ORIFICES
MAIN
ORIFICES
I_ _I A 34SL or 51SN orifice
will be used on all
burners.
r
Use 108×L or
190×N orifices
forall burners.
A. Return the unused orifices to the holder. Reattach
the holder and the instruction sheet with screw
in the original storage location.
B. Replace the burner heads, caps and top grates.
On range models,replace rear vent trim.
CHANGE GRILL ORIFICE
(if present}
Locate the 1-1/2" long Grillorifice.
Selectfor your gas type. LP--.047, NAT--.067
A. Removethe grill cover,
grates and grate frame. Lift
the radiant baffle straight
up and off.
B. Removethe 2 hex
head screws from
the top of the igniter.
• Removeone screw
from each side of
the burner surround.
• Lift out the surround.
C,
D°
Cardully push the
igniter aside and
under
the burner.
Do not pull or pinch
the wire.
Remove4 burner
attachment screws,
2 at the front and 2
at the back. Slidethe
burner assembly
toward the back and
out of the gas inlet.
Usea 1/2" deep well
socket to remove
and replace the orifice.
Reversethese
steps to re-assemble
the grill. Be sure to
place the unused
orifice in the holder
for possible future use.
lUUUU UUUUUUlIIIIIII UUUUl
Remove2--
hexhead--_ _ --,
screws I
i i / !
Surround
Screws
Burner Igniter
Surround
Assembly
Frontof Range
22