GE ZDP484NG Installation Instructions Manual page 15

Installation
STEP 7 LEVEL THE RANGE
AWARNING
The range must be level and be supported
by the legs-not the wheels. The range could move
if the wheels make contact with the floor. Be sure all
legs make contact with the floor in any installation.
• All legs must be leveled after the product is
installed.
• Check to be sure the adjoining cabinets/
countertops are level, front to back and left
to right across the opening of the range.
• Measure the distance from the floor to the top
of the countertop in the left and right rear corners.
• Adjust the height of the range to countertop height
or higher.
IMPORTANT: Thisrange should always be installed
at countertop heightor higher. DO NOT INSTALL
THE RANGE LOWER THAN ADJACENT COUNTERTOP
HEIGHT. The range must be supported by all 4 legs,
regardless of countertop height.
FRONT LEG ADJUSTMENT
• Slide front cylinders up to adjust front leveling
legs. Be careful not to damage cylinder.
• A leveling leg wrench is supplied. Reach under
the front of the range near the right side. Locate
and remove a thumb screw, then slide wrench out
of the slot.
ThumbScrew
Slide leg
cylinder up.
• Use the supplied wrench to turn the front leveling
legs. Turn clockwise to raise the range above the
wheels. Turn counterclockwise to lower the legs.
• Be sure to return the wrench to its storage slot
for future use.
15
STEP 7 LEVELTHE RANGE (cont.}
REAR LEG ADJUSTMENT
• Remove two screws from rear vent trim. Slide vent
trim forward, then lift up to remove.
• Find the two rear leg extension rods. Use a 1/4"
driver or wrench to adjust the left or right rear legs.
RearVent_im
RearLeg
Extension Rod
• Replace the rear vent trim using the original screws.
STEP 8 REPLACE OVEN DOOR(S}
Skip this step if oven doors are in place.
IMPORTANT: Do not lift the door by the handle.
To replace the oven doors:
• Firmly grasp the door at the top sides.
This is critical.
• Approach the range with the door angled
in a vertical position.
• Guide the hinges into the slots.
• Push the door in firmly while opening.
• Once in position, open the door completely.
Push the hinge locks back in and toward
the front frame.
CAUTION:
Take care when replacing
the oven doors.If the hinge latchisnot securely
locked, the hinge may snap back and separate.
If the hinge separates, you must apply pressure
(possibly w ith your foot) to press itback together
and then engage the hinge latch.