GE ZDP484NG Installation Instructions Manual page 16

Installation
STEP9 CHECK BURNERS
Check to be sure that burner heads and caps
are securelg seated.
Burner CapProperly Seated
i
Burner CapNot Properly Seated
• Check for proper ignition:
- Push in one control knob and turn to LITE
position.
- The igniter will spark and the burner will light;
the igniter will cease sparking when the burner
is lit.
- First test mag require some time, while air
is flushed out of the gas line.
- Turn knob to OFF.
- Repeat the procedure for each burner.
IMPORTANT: If the igniter electrodes continue
to spark after the burners are lit, check that
each burner component is assembled properlg.
Refer to the Owner's IVlanual.
• Burner flames should be blue and stable with no
gellow tips, excessive noise or lifting of the flame
from the burner. If ang of these conditions exist,
check that the burner ports are not blocked.
If one of these conditions continues, call for
service.
FINALIZE INSTALLATION
Place the burner grates over the burners.
The grates should be seated and should not rock.
The griddle is secured with screws. It is designed
to be stationarg and should not be removed.
The griddle has two leveling screws beneath
the rear flue cover that can be used to adjust
to the desired slope.
GriddleFlueCover
_Screws
The two inner screws ore clumping screws for
securing the griddle in place. Loosen these two
screws before leveling. Do not remove these two
screws.
The two outer screws are leveling screws. Do not
remove these two screws. They can be turned to
level the griddle or to provide a forward slope to
help grease and oils drain awag from the food
being cooked.
After leveling the griddle, hand-tighten
the clamping screws; do not over-tighten.
16
INSTALLATION CHECKLIST
Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation
air to the range is unobstructed.
Recheck Steps:
Double check to make sure evergthing in this
manual has been completed. Rechecking steps
will ensure safe use of the range.
NOTE: The rating plate is located on the bottom
of the control panel and is visible when the oven door
is opened. The model and serial number is behind
the left knob and is visible when the knob is pulled off.