GE ZDP484NG Installation Instructions Manual page 19

ZXADJB30PSS, ZXADJB36PSS, ZXADJB48PSS Accessorg Installation
ACCESSORIES--30" TO 36" ADJUSTABLE BACKSPLASH (not included}
AWARNING:
To prevent ignition of combustible materials,
the entire back wall above the range must
be protected bg a backsplash constructed
of non-combustible material.
BEFORE YOU BEGIN
Read these instructions completely
and carefullg.
IMPORTANT: Save these instructions for local
inspector's use.
IMPORTANT: OBSERVEALL GOVERNING CODES
AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these
instructions with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with your Owner's Manual for future reference.
• This backsplash adjusts to fit the space between
the top of the range and the bottom of the hood,
from 30" Min. to 36" Max. height.
• Maximum shelf load-bearing weight is 40 Ibs.
TOOLS AND MATERIALS REQUIRED
• Gloves to protect against sharp edges
• T-15 and #2 Phillips screwdrivers
• Drill with 3/32" and 9/64" bits
• Safetg glasses
• Level TopCover
• Pencil with Shelf
TopWall
Support
This Kit Includes
• Top wall support
• Bottom wall support
• Top cover with shelf
• Bottom cover
BottomWall Support
• Hardware package with
- 9 Stainless Steel Torx 15 #8
self-tapping screws
- 9 Phillips #2 pan head wood #10 screws
- 3 Stainless Steel #2 truss head
#10 screws (for alternate
installation method)
Hardware
Package
INSTALL THE WALL SUPPORT PANELS
WARNING: The wall s upport panels
must be securel 9 fastened to the wall. Failure to
do so could result in damage or personal injurg.
IMPORTANT: T his backsplash is designed to cover the wall
between the bottom of the hood and the top of the range.
The vent hood should be installed over the rangetop or
range before installing this backsplash.
• Install and levelthe Range/Rangetop according
to the product installation instructions.
• Removebacksplash packaging and protective film.
Locate wall studs on each side. Where studs are not
available, plan to use wall anchors (not provided).
Use a level to pencil 2 horizontal lines on the wall,
one 1/8" below the vent hood and the other 1/8" above
the Range/Rangetop.This 1/8" space allows the cover
panels to overlap the wall supports.
Secure the top wall support panel to the wall with 4 wood
screws, through the outermost studs.
Use 4 wood screws to secure the bottom wall support
panel. The center slot should be positioned at the top.
The gap between the top and bottom support panels
will be covered bUthe top cover with shelf.
Securethe top
panelto the wall
with 4 wood
screws
Wood
Screws
Secure
the bottompanel
to the wall with
4 wood screws
19